| Installation Tutorials
Vehicle Car Door Protection Installation
A step-by-step guide on how to install any of our Car Bumper Protection products. Our bumper protectors, corner bumper guards, door edge guards, and car door guards. are simple to install. Follow the easy step by step directions for a seamless installation of our bumper protector and rear bumper protectors.
Weather Conditions (Installation):
 |
Hot Weather Installation and Removal Tips
Best installation is at temperatures above > 60 degree F. The hotter the better, as the bumper guards are more flexible and adhere better when warm. Also, removing the bumper protectors is easier when the temperature is hot outside. To remove pull back slowly - if product does not pull off easily use a hair dryer to warm the product or park in direct sun to warm the product. |
|
 |
Cold Climate Installation and Removal Tips
During the cold months when the outside temperature is below <60 degree F, it is best to install the bumper guards indoors (in a heated space). keep the bumper guards indoors until ready to use. For installation below 60 degrees you may need to use a hairdryer or heater to warm the product and/or vehicle surface. Note: The bumper guards get stiffer as the weather gets colder, so removal may be more difficult. A hairdryer can be used to warm the product, which makes removal easier. Heat one section at a time. |
Vehicle Car Door Guard Installation
Installation - The following video will demonstrate the correct tips, tools and technique for correct rear bumper guard and bumper protector installation. The installation of bumper guards, door edge guards, and car door protectors is fast and easy. This tips and techniques video will cover the following information: surface preparation, measuring and attachment instructions. Please visit http://www.bumperdefender.com for more information.
Installation - Basic install techniques of car door protection with formed end tips. Car door guard and car door protectors installation is fast and easy. This installation video covers surface preparation, measuring and attachment instructions. Car door protectors with formed end tips are available in over 50+ colors to match your vehicles paint.
 |
VEHICLE DOOR GUARDS ARE BEST INSTALLED MIDWAY UP THE DOOR
(1) USE BLUE TAPE AS A GUIDE: Attach one end of the painters tape to the front wheel edge and continue to pull the tape until you reach the back wheel edge.
*** It’s best to apply the tape in a single sweeping motion to achieve a perfect straight line.
(2) Car door guards come as a single piece with formed end at either end. You need to cut the car door guards into 2 parts, one for the front door and the other for the rear door. Use a measuring tape. |
 |
WHEN INSTALLING CAR DOOR GUARD ON THE REAR DOOR LEAVE 1-2 CM SPACE FROM DOOR EDGE, OTHERWISE BACK DOOR WILL NOT OPEN
(3) Apply front car door protector first. Start at the door edge and work your way to the front.
(4) Apply rear door protector next. (VERY IMPORTANT) Start 1-2 cm from rear door edge(See Figure 2 above) and work your way to the rear. |
 |
Car door guard will offer the best vehicle car door protection against door dings and dents, a common occurrence in parking lots. A car door is easily dented and dinged, so without car door guards your car is at risk every time you park. Get vehicle door guards and put a stop to car door dings and dents!!! |
|
